- remove the two screws from the dock-connector end of the iPhone.
- there is a rubber gasket between the silver front bezel and black display assembly. Some force is required to separate the iPhone’s display.
- to remove the display use a small suction cup on lower end (near the Home button) and pull up the bottom section of the display.
- the display is still connected to the PCB by 3 cables, so don’t try to remove it at this point. Rotate the display up until it is at an angle of approximately 90 degrees. Gently pull up the cables one by one.
Monthly Archives: February 2010
Feb
19
2010
How to open iPhone 3G / 3GS
1

